Caring for Digital Camera

Caring for Digital Camera

1. Avoid direct contact with sunlight.

Keep your digital camera you do not get sunburnt or exposed to direct sunlight and excessive. For tinggidapat heat damage camera parts made of plastic and rubber as well as other electronic components

2. Keep your digital camera to avoid excessive shock.

Do not forget to put it in taskhusus camera, in order to avoid excessive shocks to the external environment and the clash between equipment.

3. Clean the camera and lens.

Camera should be cleaned once a week or on a regular basis and periodically. For the physical part of the camera using a dry, rough bersihdan not. While the inside and small elements, use a blower or blowers that are sold in stores camera.

4. Avoid scratches on the lens.

To avoid scratches, lens should have a permanent filter installed threaded front section. A common filter is a type of filter to be protective UV (ultraviolet) or skylight filter. Meanwhile, to avoid scratches on the back of the lens try to always put bodycup when the lens cover is removed from the camera body.

5. Avoid sea water.

Sea water is very bad and causes corrosion potential towards the camera or other electronic device. Unless specifically designed for sea water. If at any time, your camera accidentally plunged into the sea water then soak your camera directly into fresh water, then rinse several times to remove the traces of sea water. Then taken immediately to a camera repair specialist to clean.

6. Do not be too frequent cleaning or cleaning the inside of the lens when moldy. Because glass is so sensitive lens. For more frequent cleaning can also result in poor image quality.

7. Do not keep them in the closet. Because it can invite fungus that attaches to the inside of the camera lens.

8. Beware of mothballs.

Because camphor is the most potent destroyer of the camera, which can wipe wiping the camera and the other camera-based rubber.

In an electronic camera mothballs can damage path on the PCB (printed circuit board) which is where the camera is mounted chips and some elements of the chip itself. Even camphor vapor can also tarnish and make spots on the lens.